Thông số kỹ thuật:
1. Điện áp đầu vào 5V.
2. Đầu ra ADC : ( AOUT)
3. Đầu ra DAC : ( DOUT )
4. Các chân giao tiếp được ghi trực tiếp trên mạch
Thông số kỹ thuật:
- Kích thước: 32 x 22 x 27 mm
- Điện áp cung cấp: DC 5V.
- Có 2 dạng tín hiệu đầu ra dạng Analog và TTL.
- Tín hiệu đầu ra TTL có giá trị thấp. (đầu ra tín hiệu mức thấp có thể được kết nối trực tiếp với vi điều khiển).
- Đầu ra tương tự 0 ~ 5V, nồng độ cồn càng cao điện áp càng cao.
- Độ nhạy cao và chọn lọc tốt với hơi ethanol.
Thường được dùng trong các thiết bị kiểm tra chất lượng không khí bên trong cao ốc, văn phòng, thích hợp để phát hiện NH3, NOx, Ancol, Benzen, khói, CO2,…
Thông số kỹ thuật:
Thông số kỹ thuật:
Thông số kỹ thuật:
Thông số kỹ thuật:
1. Điện áp đầu vào 5V.
2. Đầu ra ADC : ( AOUT)
3. Đầu ra DAC : ( DOUT )
4. Các chân giao tiếp được ghi trực tiếp trên mạch
Thông tin sản phẩm:
MQ-4 Gas Sensor Module Methane Gas Detective Sensor
Methane Gas Detective Sensor MQ-4 Gas Sensor Module
MQ-4 Gas Sensor Module Methane Gas Detective Sensor MQ-4
Module Applications:
Suitable for home or factory methane gas , natural gas and other monitoring devices to test natural gas, methane 300 to 10000ppm;
Module Features :
1. Using high-quality dual-panel design, with power indicator and TTL signal output instructions ;
2. The switching signal having a DO (TTL) output and analog output AO ;
3. TTL output valid signal is low . ( Low-level signal when the output light can be directly connected to the microcontroller or relay module )
4. The higher the voltage , the concentration of the analog output voltage is higher.
5. For methane, natural gas has a good detection sensitivity.
6. There are four screw holes for easy positioning ;
7. Dimensions : 32 (L) * 20 (W) * 22 (H)
8. Rapid response and recovery characteristics
Electrical properties:
Input voltage: DC5V Power consumption ( current ): 150mA
DO output: TTL digital 0 and 1 ( 0.1 and 5V)
AO output:0.1-0 .3 V ( relative to pollution ) , the maximum concentration of a voltage of about 4V
Special note: After the sensor is power on, it needs to be warmed up around 20S, measured data can be stable , sensor become warm is a normal phenomenon.
The instruction of Wiring:
1. VCC: positive power supply (5V)
2. GND: power supply is negative
3. DO: TTL switching signal output
4. AO: analog signal output